NEC Express5800 Series User Manual page 106

Chapter 2 Preparations
(2) Removal procedure
Remove the server from the rack in the following procedure. This can be removed by one person but it is
recommended more than one person work on this together.
1. Make sure that the server is turned off and then disconnect the power cord or all cables from the
server.
2. Unlock the front bezel and remove it.
3. Slowly pull the server out while pressing
the unlock buttons located on either side
of the front of the server.
4. Because there are stoppers, the server
will come to a stop halfway. Press and
hold the stoppers on the rails and pull the
server out of the rack.
5. Hold the server firmly and remove it from the rack.
106
Important
Be careful not to get your fingers caught in the rails and levers.
Important
• While more than one person is supporting the bottom part of the server,
slowly pull out the server.
• Do not apply pressure on the server from top when it is being pulled out.
Doing so cause the server to drop, which is dangerous.
• Be careful not to get your finger caught in rails.
Express5800/R110e-1E User's Guide
2. Installation and Connection
Key slot
Press the button
to unlock
Stopper