Install The Ultraglide Sensors; Boom Sensor Mounting Locations - Raven AutoBoom Installation Manual

For spra-coupe 7x60

Hide thumbs Also See for AutoBoom:

Table of Contents

Chapter 4

Install the UltraGlide Sensors

Sensor mounting locations may be influenced by the boom configuration. Determine the appropriate location

for mounting the sensors on the boom, ensuring the sensors will not interfere with or be damaged while folding

or unfolding the booms. The sensors should be mounted outside of the boom fold, but inside the boom

breakaway.

Mount the Boom Sensors

Mounted Boom Sensor

FIGURE 7.

Secure the right sensor (P/N 063-0130-012) to the front of the right boom using two 1-9/16" W x 2-1/2" L x

3/8" thread U-bolts (P/N 107-0171-611) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).

Tighten the nuts to ensure the sensor is mounted securely.

Repeat the steps above to mount the remaining boom sensor(s).

The machine must remain stationary and

switched off, with the booms unfolded and

supported, during installation or maintenance.

Spra-Coupe 7X60 (2010 & Newer) AutoBoom® Installation Manual

WARNING

Table of Contents