Install The Ultraglide Hydraulic System; Install Fittings On The Autoboom Valve - Raven AutoBoom Installation Manual

Install the UltraGlide Hydraulic System

Install Fittings on the AutoBoom Valve

Before mounting the AutoBoom valve on the machine, install the proper fittings on the valve. This prepares the
valve for installation and simplifies the hose connection process later in the procedure.
Refer to the following table to install the fittings in the appropriate ports on the AutoBoom Valve.
Fitting - 7/16" JIC (M) to 9/16" SAE O-Ring (M) Straight Adapter Fitting
Fitting - 9/16" JIC (M) to 9/16" SAE O-Ring (M) Straight Adapter
Fitting - 3/4" SAE O-Ring (M) to 9/16" JIC (M) Straight Adapter
Fitting - 9/16" JIC M/M/F Swivel Run Tee
Fitting - 9/16" JIC (F) to 7/16" JIC (M) Straight Adapter
Fitting - 3/4" SAE O-Ring (M) to 3/4" JIC (M) Straight Adapter
Manual No. 016-0230-005
The machine must remain stationary and
switched off, with the booms unfolded and
supported, during installation or maintenance.
Fitting
WARNING
Part Number
333-0012-044
333-0012-045
333-0012-046
333-0012-043
333-0012-159
333-0012-093
UltraGlide
Port
LV, RV
LC, RC
RT CYL RTN,
LF CYL RTN
RT CYL RTN,
LF CYL RTN
90° end of installed
fittings in
RT CYL RTN,
LF CYL RTN
P, T, EF
35