Install The Ultraglide Hydraulic System; Install Fittings On The Autoboom Valve - Raven AutoBoom John Deere 4700 Installation Manual

Install the UltraGlide Hydraulic System

Install Fittings on the AutoBoom Valve

Before mounting the AutoBoom valve on the machine, install the proper fittings on the valve. This prepares the
valve for installation and simplifies the hose connection process later in the procedure.
Use the following table to install the fittings in the appropriate ports on the AutoBoom valve.
11/16" ORFS (M) to 9/16" SAE O-Ring (M) (P/N 333-012-084)
11/16" ORFS (M) to 3/4" SAE O-Ring (M) (P/N 333-012-199)
9/16" ORFS (M) to 7/16" SAE O-Ring (M) (P/N 333-012-209)
11/16" ORFS (M) 90° to 3/4" SAE O-Ring (M) Elbow, (P/N 333-012-165)
9/16" JIC (M) to 3/4" SAE O-Ring (M), Orifice (P/N 333-012-230)
Note:
Remove fittings from rod and barrel end of tilt cylinders to see if orifices are installed in cylinder
ports.
If orifices are found in cylinder ports, remove orifices and install the ROD END orifices into 'LV' and
'RV' port on the AutoBoom valve (FLAT SIDE AWAY).
If offices are not found in the cylinder ports, continue with the installation.
Manual No. 016-0230-012
This machine must remain stationary and
switched off with the booms unfolded and
supported while installation or maintenance is
conducted.
Fitting
WARNING
LV, RV, LC, RC
T, P
LS1
Outside LT CYL RTN, Outside RT CYL
RTN
Inside LT CYL RTN, Inside RT CYL
RTN
UltraGlide
Port
55