Mount The Center Rack Sensor; Connect The Sensor Cables - Raven AutoBoom Installation Manual

Mount the Center Rack Sensor

Mounted Center Rack Sensor
FIGURE 8.
Mount the center sensor (P/N 063-0130-018) to the machine's center rack using two 1-9/16" W x 2-1/2" L x
1.
3/8" thread U-bolts (P/N 107-0171-611) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Tighten the nuts to ensure the sensor is mounted securely.
2.

Connect the Sensor Cables

Connect the left sensor cable (P/N 115-0230-051) to the connector on the left outer sensor.
1.
Route the left sensor cable toward the AutoBoom valve.
2.
Loop and tie-off any excess cable, allowing enough cable for boom folding and extension.
3.
Repeat the steps above to connect the remaining sensor cables.
4.
Note:
The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.
Manual No. 016-0230-098 Rev. C
UltraGlide
37