Cable Connection To The Wireless Communication Module - Siemens SITRANS F M MAG 8000 Series Operating Instructions Manual

5.3

Cable connection to the Wireless Communication Module

Note
Shielding
One end of each cable must have its shield connected to protective earth. If a connector is used
at this end, the shell of the connector must be connected to the shield of the cable.
1. Snap small connector in GSM/GPRS module.
2. Prepare coupling cable for physical analog inputs, see Figure 11-1 Analog inputs cable
connectors (Page 78) for pin description.
SITRANS FM MAG 8000 3G/UMTS add-on module
Operating Instructions, 03/2020, A5E03644134-AC
WARNING
Overvoltage
Overvoltage to analog inputs may damage internal electronic components!
Analog input 1 (current input) must not be connected directly to a power supply source.
Analog input 2 (ratiometric) must not exceed 6 VDC.
5.3 Cable connection to the Wireless Communication Module
Connecting
29