Whitelist; Clear Whitelist; Manual Network Registration - Siemens SITRANS F M MAG 8000 Series Operating Instructions Manual

Operating

7.9 Manual network registration

7.7

Whitelist

To ensure that only authorized persons can configure the Wireless Communication Module
create a Whitelist. In the whitelist, up to three mobile phone numbers can be authorized to send
configuration commands. To fill the whitelist, you can set the parameters P4, P5 and P6.
See Configuration commands (Page 33).
For example if you want to authorize three mobile phone numbers (+4911111111,
+4922222222 and +4933333333), the configuration command is:
Configuration;P4=+4911111111;P5=+4922222222;P3=+4933333333;
The whitelist can be cleared by an SMS command which must include the PIN code: see Clear
whitelist (Page 54).
Note
An empty whitelist provides no protection, because configuration commands are authorized for
any mobile phone.
7.8

Clear whitelist

The whitelist can be cleared by any mobile phone which enters the correct PIN code. This
command is useful if the mobile phone numbers have changed and can not be accessed
anymore.
Request syntax:
RESETMSISDN;[PIN];
Example:
RESETMSISDN;1000;
After clearing the whitelist, an alarm SMS will be sent to the registered alarm recipients. The
alarm SMS will contain the mobile phone number which triggered this command to track a
potential security breach.
Example:
123456H123 2017-09-12 13:25
MSISISDN: +4912345678
RESETMSISDN: OK
7.9 Manual network registration
Network selection
The Wireless Communication Module will automatically register to the network predefined in
the SIM card.
54
SITRANS FM MAG 8000 3G/UMTS add-on module
Operating Instructions, 03/2020, A5E03644134-AC