Siemens SITRANS F M MAG 8000 Series Operating Instructions Manual page 92

Configurations
C.3 Configuration of alarm messages
Example:
You want to receive an alarm SMS for the alarms AL01, AL02, AL05 and AL08. Your binary
number should look like this:
AL16 AL15 AL14 AL13 AL12
0 0 0 0
Configuration command
To set the parameter P58, you need to convert your binary number into the hexadecimal
system. In our example, 0000 0000 1001 0011
send the configuration command to the Wireless Communication Module. In our example, the
configuration SMS looks like this:
Configuration;P58=0x0093;
Note
The active alarm message will be put in column K of the CSV file, regardless of the alarm SMS
settings in parameter P58.
Table C-2 Alarms for the Wireless Communication Module and MAG 8000
Alarm No. Wireless Communication Module alarm
AL01 Signal strength below limit
AL02 Data connection not available
AL03 For internal use
AL04 For internal use
AL05 Problem with configuration
AL06 WCM can't send SMS
AL07 WCM can't send measurement data
AL08 Unauthorized access
AL09 Remaining battery capacity below 10%
AL10 Wrong configuration
AL11 For internal use
AL12 Power up failure
AL13 For internal use
AL14 For internal use
AL15 20 mA alarm
AL16 5 mA alarm
92
AL11 AL10 AL09
0 0 0 0
AL08 AL07 AL06 AL05
1 0 0 1
converts into 0x0093
bin
Alarm No. MAG 8000 alarm
AL17 Insulation fault
AL18 Coil current fault
AL19 Amplifier overload
AL20 Data checksum fault
AL21 Low power
AL22 Flow overload
AL23 Pulse A overload
AL24 Pulse B overload
AL25 Consumption interval over limit
AL26 Leakage
AL27 Empty pipe
AL28 Low impedance
AL29 Flow over limit
AL30 Not in use
AL31 Not in use
AL32 Not in use
SITRANS FM MAG 8000 3G/UMTS add-on module
Operating Instructions, 03/2020, A5E03644134-AC
AL04 AL03 AL02 AL01
0 0 1 1
. Finally you need to
hex