Safety Notes; General Safety Instructions; Laws And Directives - Siemens SITRANS F M MAG 8000 Series Operating Instructions Manual

Safety notes

2.1

General safety instructions

Correct, reliable operation of the product requires proper transportation, storage, positioning
and assembly as well as careful operation and maintenance. Only qualified personnel should
install or operate this instrument.
Note
Alterations to the product, including opening or improper modifications of the product, are not
permitted.
If this requirement is not observed, the CE mark and the manufacturer's warranty will expire.
2.2

Laws and directives

General requirements
Installation of the equipment must comply with national regulations: for example EN 60079-14
for the European Community.
Observe ALL test certification, provisions and laws applicable in your country during
connection, assembly and operation.
FCC/INDUSTRY CANADA NOTICE
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Any
changes or modifications not expressly approved by Siemens could void the user's authority to
operate this equipment.
Instrument safety standards
The device has been tested at the factory, based on the instrument safety standards. In order
to maintain this condition over the expected life of the device the requirements described in
these operating instructions must be observed.
SITRANS FM MAG 8000 3G/UMTS add-on module
Operating Instructions, 03/2020, A5E03644134-AC
CAUTION
2
11