System Error; Touch Switch Is Active - Fuji Electric POD UG221H-LE4 User Manual

7-4
1. Error Message
4.

SYSTEM ERROR

When a system error is detected, the following error screen is displayed on the POD.
ERROR: XX
1:
11:
30:
31:
32:
33:
34:
35:
The source of the error could be one of the following three problems. Contact your local distributor.
1) Program crash due to noise
2) Hardware problem
3) Bad program
Solve relevant problems by following the directions in "Troubleshooting" (page 7-5).
If the problem persists, contact your local distributor.
5.

Touch Switch is Active

If the power is turned off while a touch switch is
activated, the error screen shown on the right is
displayed.
Remove your finger from the screen.
If the error screen remains displayed, contact your
local distributor.
SYSTEM ERROR : 32
TEA : XXXXXXXX
SSR : XXXXXXXX
R0 : XXXXXXXX
R2 : XXXXXXXX
R4 : XXXXXXXX
R6 : XXXXXXXX
R8 : XXXXXXXX
R10 : XXXXXXXX
R12 : XXXXXXXX
R14 : XXXXXXXX
Watch dog timer error
Switch table error
Request for displaying full error
Memory allocation system error
General exceptions/MMU address system error
RTOS system error
Memory error
Inaccurate memory error
SYSTEM
EXPEVT : XXXXXXXX
F1
SPC : XXXXXXXX
R1 : XXXXXXXX
F2
R3 : XXXXXXXX
R5 : XXXXXXXX
F3
R7 : XXXXXXXX
R9 : XXXXXXXX
F4
R11 : XXXXXXXX
R13 : XXXXXXXX
F5
R15 : XXXXXXXX
POWER
Check
Touch Switch is active.
Keep hand off the screen.
POWER
SYSTEM
F1
F2
F3
F4
F5