Transferring Screen Data; Barcode Reader Connection - Fuji Electric POD UG221H-LE4 User Manual

2-10
5. Modular Jack (MJ1)

Transferring Screen Data

• Use modular jack 1 (MJ1) when transferring screen data.
• When [Editor Port] is selected for [Modular Jack 1] on the editor, it is possible to transfer data in the
RUN mode because the RUN/STOP mode (on the Main Menu screen) can be automatically
selected.
Also RUN/STOP mode is automatically selected for on-line editing and simulation.
• When an option other than [Editor Port] is selected for [Modular Jack 1], select the STOP mode
(on the Main Menu screen) and transfer screen data. Simulation or on-line editing is not available.
• When transferring screen data, use our data transfer cable (UG00C-T) 3 m to connect the Simple
POD to a personal computer.

Barcode Reader Connection

• It is possible to receive the signal from a barcode reader by connecting the barcode reader at the
modular jack (MJ1) of the Simple POD.
• To connect a barcode reader to the modular
jack (MJ1), use our optional cable (UG00C-B).
Length: 3 m
with modular plug
• Notes on connection
- In the case of barcode readers with CTS
and RTS control, it may be necessary to
install a jumper to RTS and CTS.
Otherwise the barcode reader may not
work correctly.
- The external power supply (+5 V) is max.
150 mA.
(Refer to page 2-9.)
• When using the barcode reader that was connected to UG210 (UG Series' old version), connect it
to the D-sub 9-pin female connector using the UG00C-B cable as shown below.
Barcode reader
Signal
Name
RTS
TXD
RXD
CTS
SG
+5V
D-sub 9-pin (female)
Signal
Name
Pin No
1 CS
Orange: RD
2 RD
Yellow: SD
3 SD
4 RS
5
6
7 SG
Red:
8
Brown: +5 V
9 +5V
Brown: +5 V
Red: 0 V
Orange: RD
Yellow: TD
* Install a jumper between
CTS and RTS.
0 V