Fuji Electric POD UG221H-LE4 User Manual page 60

6-12
2. Main Menu Screen
Messages during Data Transfer
If an error occurs during data transfer, the message
window shown on the right is displayed.
The kinds and the contents of the messages are shown below. The same messages are used for the
memory card and CF card. When using the CF card, the "memory card" in the explanation should
read as the "CF card".
Messages
Work normally finished.
UG00P-MR not connecting
UG00P-MR Communication Error
Memory-Card not setting
Memory-Card Capacity over
Write Protect: ON
Writing Error occurred.
Selected data does not exist.
UG type is different.
Selected data can not be read.
Reading Error occurred.
Data discrepant
Screen data on UG will be broken.
Undefined Error occurred.
The specified operation has been concluded normally.
No card recorder is connected when selecting a modular jack.
A communication error occurred between Simple POD and UG00P-MR when selecting a
modular jack.
Memory-Card not setting
Cannot write the data into a memory card because the data size in Simple POD is larger
than the capacity of a memory card.
Cannot write data into a memory card because the write protect switch in a memory card is
ON.
The error occurred while writing data into a memory card.
The data in the reading target does not exist.
The specified type of the data in Simple POD is different from the type of the memory card
data.
The data in a memory card cannot be read.
The error occurred during writing data into a flash ROM of Simple POD.
There is some discrepancy in data, when comparing data between a memory card and
Simple POD.
Warning about data destruction in Simple POD that may occur when transferring the font
data larger than the present data from a memory card to Simple POD.
(The [OK] switch continues transferring; the [Cancel] switch stops transferring.)
The error occurred due to some cause other than mentioned above.
Contents