Fuji Electric POD UG221H-LE4 User Manual page 35

Battery Replacement Procedure
Replacement batteries are available from Hakko Electronics.
Name
Replacement battery for
the Simple POD
1. Replace the battery "UG30P-BT" within three minutes after the unit is turned off.
If it is not possible to replace within three minutes, use the editor (cable: UG00C-T) or a CF card
and make a backup copy of data in the SRAM.
1) Start the editor.
2) Click the [Transfer] icon. The [Transfer] dialog is displayed.
3) Select [Display] for [Transfer Device] and [SRAM Data] for [Transfer Data].
4) Click the [PC <-] under [Transfer].
5) Save the read data in the "∗.RAM" file.
2. Turn the unit off. Open the battery holder slowly. A battery set in the socket will come into view.
3. Unplug the battery connector, and remove the battery from the socket.
Take out the battery while pressing the center of the battery holder cover
as shown in the figure at right.
4. Set a new battery. Fit the battery into the socket in such a manner that the red cable side of the
battery faces the board and the cable branches from the bottom. Insert the battery in the "b" side
first, and push it down to "b" while inserted in the "a" side.
Battery connector
5. Plug in the battery connector and close the battery holder cover.
6. Remove the existing caution sticker. Enter a date five years from now for "Battery replacement" on
the new caution sticker, and attach it to the backside of the unit.
7. When the backup copy of the SRAM data has been saved in step 1, turn on the unit and load the
data to the unit.
1. Coin-type Lithium Battery (UG221H-SR4 and LR4 only)
Type
• Coin-type lithium primary cell 1 pce
UG30P-BT
• Cautions sticker 1 pce
Printed circuit board
Battery holder cover
Contents
See operating or maintenance
instruction for type of battery
to be used.
Battery replacement.
"b" side
Socket
CN1
"a" side
4-3
4