Fuji Electric POD UG221H-LE4 User Manual page 71

7-6
2. Troubleshooting
Symptom
"SYSTEM ERROR: xx"
occurs.
SYSTEM ERROR : 32
SYSTEM
TEA : XXXXXXXX EXPEVT : XXXXXXXX
F1
SSR : XXXXXXXX SPC : XXXXXXXX
R0 : XXXXXXXX R1 : XXXXXXXX
F2
R2 : XXXXXXXX R3 : XXXXXXXX
R4 : XXXXXXXX R5 : XXXXXXXX
F3
R6 : XXXXXXXX R7 : XXXXXXXX
R8 : XXXXXXXX R9 : XXXXXXXX
F4
R10 : XXXXXXXX R11 : XXXXXXXX
R12 : XXXXXXXX R13 : XXXXXXXX
F5
R14 : XXXXXXXX R15 : XXXXXXXX
POWER
Switches do not work.
The screen becomes dark or
black.
Screen data cannot be
transferred.
Cause
The following causes are probable, depending
on the symptoms.
1) Turning the power off and back on corrects
the error.
↓
Communication failed because of improper
timing.
2) Turning the power off and back on does not
correct the error.
↓
A certain condition always causes the error.
Or the POD is faulty.
1) Switches do not work in the RUN mode. A
beep sounds.
↓
Is the switch interlock enabled?
2) Switch activation position is wrong.
On the "I/O Test" screen displayed from the
Main Menu screen, press the [Switch
Check] switch. On the touch switch test
screen, a position different from the
pressed position is activated.
↓
The switch activation position may be
misaligned.
3) Switches do not work even in the STOP
mode.
On the "I/O Test" screen displayed from the
Main Menu screen, press the [Switch
Check] switch. When the touch switch test
screen is pressed, nowhere is activated.
↓
POD switches may be faulty.
1) Touching the screen restores it to the
previous illuminated state.
↓
The backlight operates automatically as
preset.
2) Touching the screen does not restore it.
However, the POWER lamp is lit.
↓
The backlight may be at the end of its life.
Or the POD may be faulty.
1) Screen data transfer has never succeeded.
↓
There may be some errors in the settings
on the computer.
2) Screen data transfer was possible, but is
disabled now.
↓
The POD may be faulty. Or, there may be
some errors in settings.
Solution
1) If communication is stable after turning the
power on again, continue and observe
operation.
2) Make a note of the information on error
number, etc. displayed on the screen and
contact your local distributor.
1) Check the settings of switch functions, etc.
on the editor.
2) Perform a touch switch adjustment (page
6-9).
3) Return the POD to your local distributor.
1) The time for turning off the backlight can be
changed on the editor.
2) Return the POD to your local distributor.
1) In the [Transfer] dialog box on the editor,
decrease the baud rate by one level. Also
check that the correct COM port is
selected.
2) Check if the modem connection mode is
selected. ("Modem Connect Mode"
displayed at the bottom of the Main Menu
screen denotes the mode)
Also perform an RS-232C self-loop test
(page 6-5).