Edit Repeat Count - Interactive Technologies SceneStation User Manual

Edit Repeat Count

When a preset has a loop back to another preset, you can specify that the loop
should only occur a specific number of times. By default, loops repeat always.
Press the REPEAT button to switch to the Repeat Count mode. The center LED on
the station will blink Magenta (the same color as the Scene button on the remote).
Then, press the number of times you want the loop to be taken. You can enter a
repeat count from 0 to 255. A repeat count of zero will cause the loop to always be
taken.
For example, to create a short loop that causes presets to execute in the order 1, 2, 3, 1, 2, 3, 1,
2, 3, 4, 5, etc., then preset 3 should have a loop back to preset 1 and a repeat count of 2. While
editing preset 3, press:
REPEAT + 2
To remove a repeat count from a preset (causing the loop to repeat infinitely), enter zero (0). For
example:
REPEAT + 0
When finished setting the Repeat property of a preset, you can either press ENTER to save the
changes and return to the station's Idle Mode, or you can press a different property button (Fade,
Follow, Loop, Repeat, etc.) to enter the value of another property.
SceneStation Installation and Programming Guide Using the Programmer's Remote | 57