Klöckner-Moeller; Siemens - Festo VIFB-02- Series Manual

VIFB1 - 02
> IFB1-02_BES_V_018474g1_1996-04N - Restored Document - 2011-12-15 <
9604
5. Commissioning
Klöckner-Moeller
If the valve terminal/valve sensor terminal is
used in the SUCONET, the following must be
observed:
• Configuration
The valve terminal/valve sensor terminal re-
acts just like the PS3 controller when used
with the SUCONET and must be configured
accordingly.
• The valve terminal only evaluates the output
information.
• The valve sensor terminal evaluates both out-
put and input information.
• A field bus slave is first initialized when it is
accessed by the program. Then the BUS-LED
goes out.
• Use only the following ID words:
- valve terminal without inputs:
- valve terminal with inputs:
Further details on the configuration are to be
found in the PLC manual of the PLC control sys-
tem.

Siemens

If the valve terminal/valve sensor terminal is
used in the ET100 bus, the following must be
observed:
PLEASE NOTE
Valve terminal/valve sensor terminals have
no periphery bus. the periphery bus trans-
mission time is therefore zero
+ ∆ t
(( T =0).
c c)
• Calculating the total transmission time
Please see the PLC manual of the control
system for the calculation of the total tran-
smission time (t ).
t max
80D4
80D8
5-5