Festo - Festo VIFB-02- Series Manual

VIFB1 - 02
Menu: FST 405 field bus configuration
PA.
Field bus address
of valve terminal/
valve sensor terminal
Fig. 5/1: Example – Configuring with the FST 405
5-4
> IFB1-02_BES_V_018474g1_1996-04N - Restored Document - 2011-12-15 <
5. Commissioning

Festo

The field bus configurator in the FST software
offers support in compiling the NOMINAL confi-
guration. Menu control and operation of the soft-
ware are described in the corresponding FST
manual for the control system.
The system should be configured as follows:
• Enter the field bus address of the field bus
slave (valve terminal/valve sensor terminal).
• Enter the line number.
• Select and enter the type of valve terminal/-
valve sensor terminal from the field bus type
file. When the type is selected, the number of
necessary input/output words (IW/OW) to be
addressed is automatically assigned.
[ Insert [Esc]
Line Type
Number of field bus
line to which
terminal is
connected.
Valve terminal 01
* Valve terminal 01
Valve terminal 02
Valve terminal 02
* Valve sensor terminal up to
Valve sensor terminal over
Decentralized I/Os
I/O extension 405
Servodriver HPM3000
IW OW
Type of field bus slave
(Type must be selected from
field bus type file).
(Type–selection)
up to
over
up to
over
8 valves
8 valves
8 valves
8 valves
6 valves
6 valves
9604