Patient Current Indicator <5; Output Indicator <6; Mains Module <7 - Physiomed IONOSON-Basic Operating Instructions Manual

2 Controls and Indicators
2.4 Patient Current Indicator <5>
Important
If the indicator does not flash during treatment, you need to carry out a self-test routine and
observe whether or not the indicator flashes. If the indicator still does not flash during treat-
ment after the check, the accessories of the corresponding channel should be checked and
replaced if necessary!
2.5 Output Indicator <6>
2.6 Mains Module <7>
8
The diode at the left side of the symbol belongs to channel I, the diode at the
right to channel II. The flashing of the indicators depends on the resistance in
the two channels. In most cases the diodes start flashing exactly at the mo-
ment when the patient starts to have a clear sensation of the current in the
corresponding channel.
The Output Indicator <6> tells you to be cautious when handling the electrodes.
CAUTION
When the Output Indicator <6> flashes, the Patient Lead Connect-
or <9> is under voltage!
Make sure you do not touch the electrodes when the current is turned
up!
The Mains Module <7> with the mains switch, is located at the rear face of the in-
strument. With the mains switch, you can switch the mains voltage of the IONO-
SON-Basic on and off.
Important
For mains supply only use the mains cable provided by the manufac-
turer!
PHYSIOMED ELEKTROMEDIZIN AG
IONOSON-Basic