Examples Of The Ip Addresses And Network Services Needed For The System. The Expansion Enclosures Are Not Shown; Expansion Enclosures Are Not Shown - IBM Storwize V7000 Unified Quick Installation Manual

A B
123.123.123.102 123.123.123.103 123.123.123.104
123.123.123.101
D
3
Figure 11. Examples of the IP addresses and network services needed for the system. The

expansion enclosures are not shown.

Legend for above graphic:
1 File storage path
v
2 Block storage path
v
3 Remote support services via internet
v
A DNS server
v
B NTP server
v
C Email server
v
D Authentication server
v
E 10 Gbps Ethernet switch
v
F Client machine
v
G Client machine
v
H Fibre Channel switch
v
AA 1 Gbps Ethernet direct connection between the file modules
v
BB 10 Gbps Ethernet network
v
CC Fibre Channel network
v
DD 1 Gbps Ethernet
v
EE Fibre Channel direct connection from file modules to node canisters
v
Note: You cannot use VLAN-based subnets to configure the system network. To
configure the Storwize V7000 Unified management IP address, file module 1 and 2
IP addresses, subnet mask, and gateway address, you must provide non-VLAN
based network information. Also, all IP addresses entered must be on the same
subnet. After the system is configured, use the chnwmgt command to change the
Storwize V7000 Unified network settings to switch to a VLAN-based subnet. This
C
E
99.99.99.1
99.99.99.100
123.123.123.10
123.123.123.11
File Module 1
123.123.123.20
123.123.123.21
Node cannister 1
AA
BB
CC
DD
EE
Chapter 1. Before you begin the installation
1
99.99.99.200
V7000 Unified
99.99.99.101
123.123.123.12
File Module 2
Control Enclosure
123.123.123.22
Node cannister 2
H
F
G
2
13