Startup Diagnostic Codes; Critical Startup Diagnostic Codes - Avaya CallPilot 202i Manual

Troubleshooting startup problems

Startup diagnostic codes

HEX display diagnostic codes are divided into the following two categories:
• critical startup diagnostics
• non critical operating system and switch diagnostics

Critical startup diagnostic codes

All critical startup diagnostics must pass before the 202i can proceed with the start sequence. If
a critical diagnostic fails, the start sequence indefinitely halts, an error code displays, and you
here a continuous beep.
The following table shows the critical startup diagnostic codes with their corresponding failure
codes. Failure of these diagnostics means that there has been a server failure. The start cycle
halts.
Note:
When a test succeeds, the next test code appears.
Test code
T:01
T:02
T:03
T:04
T:05
T:06
T:07
T:08
HOST
Avaya CallPilot 202i Server Maintenance and Diagnostics
on page 29
Test description
Internal RAM self-test
ALU self-test
Address mode self-test
Boot ROM self-test
Timer self-test
Watchdog self-test
EEPROM self-test
End of system controller self-tests
The power status LED blinks three times.
Start of BIOS diagnostics
The monitor displays the BIOS start screen.
If a critical error occurs, the start cycle halts.
Examples of critical errors are memory
Startup diagnostic codes
Failure code
F:01
F:02
F:03
F:04
F:05
F:06
F:07
not applicable
HOST continues to
scroll across the HEX
display
December 2010 25