The Netstat Command; Netstat Command Syntax - Avaya CallPilot 202i Manual

Using the operating system online diagnostic tools
To run the nbtstat command from the operating system
1. Click Start, Programs, Accessories, Command Prompt to display the command
2. At the prompt, type nbtstat with the required parameters.
3. Press Enter.
4. Type Exit to exit the Command Prompt window.

The netstat command

The netstat command displays current TCP/IP network connections and protocol statistics.

Netstat command syntax

The netstat command uses the following syntax:
netstat [-a] [-e] [-n] [-s] [-p proto] [-r] [interval]
-a
-e
-n
-s
-p proto
-r
interval
To run the netstat command from the operating system
1. Click Start, Programs, Accessories, Command Prompt to display the command
42 Avaya CallPilot 202i Server Maintenance and Diagnostics
prompt window.
The Command Prompt window appears.
The system runs the nbtstat utility.
Parameter
prompt window.
Description
Displays all connections and listening ports.
Displays Ethernet statistics. This can be combined
with the -s option.
Displays addresses and port numbers in numerical
form.
Displays the statistics for each protocol.
Shows connections for the protocol specified by proto.
Proto can be tcp or udp. If used with the -s option, proto
can be tcp, udp, or ip.
Displays the contents of the routing table.
Redisplays selected statistics, pausing between each
display. Press Ctrl+C to stop redisplaying statistics.
December 2010