Tracert Syntax; Tracert Parameters - Avaya CallPilot 202i Manual

• Tracert determines the route by sending the first echo packet with a TTL of 1 and
incrementing the TTL by 1 on each subsequent transmission until the target responds, or
the maximum TTL is reached.
• Tracert then examines the ICMP Time Exceeded messages sent back by intermediate
routers.

Tracert syntax

tracert [-d] [-h maximum_hops] [-j host_list] [-w timeout]
[target_name]

Tracert parameters

The tracert command uses the following parameters.
Parameter
-d
-h maximum_hops
-j host-list
-w timeout
target_name
To run the tracert command from the operating system
1. Click Start, Programs, Accessories, Command Prompt to display the command
2. At the prompt, type the following command:
3. Press Enter.
4. Type Exit to exit the Command Prompt window.
Avaya CallPilot 202i Server Maintenance and Diagnostics
Specifies not to resolve addresses to hostnames.
Specifies the maximum number of hops to search for the target.
Specifies a loose source route along the host list.
Waits the number of milliseconds specified by the timeout for
each reply.
The name of the target host.
prompt window.
The Command Prompt window appears.
tracert [-d] [-h maximum_hops] [j host_list] [-w timeout]
[target name]
Example: tracert 200.286.0.32 210 200.236.0.04
The system runs the tracert utility.
Description
Tracert syntax
December 2010 39