Digi XBee S2C DigiMesh 2.4 Kit Getting Started Manual page 18

Set up your XBee devices
3. Click the Detach view button
a. In the Console log area for XBEE_A, type "Hello XBEE_B!"
b. In the Console log area for XBEE_B, type "Hello XBEE_A!"
The message of the sender is in blue font, and the message of the receiver is in red font.
4. Close the window for XBEE_B.
5. Keep the serial connections open
Tip If the two XBee modules are unable to talk to each other:
Verify that you accurately configured the parameters. See
n
modules in transparent
Verify that the CH (Operating Channel) and ID (Network Identifier) are the same for both XBee
n
modules.
XBee S2C DigiMesh 2.4 Kit Getting Started Guide
to see both consoles at the same time.
for both XBee modules.
mode.
Step 3: Set up your first wireless connection
Configure the first two XBee
18