Check The Network; Send Messages Through Xctu - Digi XBee S2C DigiMesh 2.4 Kit Getting Started Manual

Set up your XBee devices

Check the network

Once both XBee modules are configured, use XCTU to check that they are in the same network and
can see each other.
1. Click the Discover radio nodes in the same network button
The device searches for devices in the same network.
When the discovery process is finished, XCTU lists discovered devices found within the network
in the Discovering remote devices dialog.
2. Click Cancel. There is no need to add the remote device that has been discovered.

Send messages through XCTU

Use the XCTU console to have your two XBee modules send messages to each other.
1. Switch both XBee modules to the consoles working mode
2. Open a serial connection for each XBee.
a. Select XBEE_A and click
b. Select XBEE_B and click
XBee S2C DigiMesh 2.4 Kit Getting Started Guide
Step 3: Set up your first wireless connection
.
.
.
of XBEE_A.
17