How To Unplug An Xbee Module; Step 2: Download And Install Xctu - Digi XBee S2C DigiMesh 2.4 Kit Getting Started Manual

Set up your XBee devices
4. After you plug the XBee module into the board, connect the board to your computer using the
micro USB cables provided.
5. Ensure the loopback jumper is in the UART position.

How to unplug an XBee module

To disconnect your XBee module from the XBee Grove Development Board:
1. Disconnect the micro USB cable (or the battery) from the board so it is not powered.
2. Remove the XBee module from the board socket, taking care not to bend any of the pins.
Make sure the board is not powered when you remove the XBee module.

Step 2: Download and install XCTU

This section contains download and install instructions based on operating system. XCTU is
compatible with Linux, OSX, and Windows. It may be necessary to configure your system prior to
installing XCTU for the first time.
If you get stuck, see
XBee S2C DigiMesh 2.4 Kit Getting Started Guide
XCTU installation error.

Step 2: Download and install XCTU

10