Manual Operation Of A-/B- Or C-Valves And Hygienic Flushings (Individually) - Kemper KHS Logic Control System Installation And Operating Instructions Manual

3.1.11 Manual operation of A-/B- or C-valves and hygienic flushings (individually)

To check the newly added A-, B- C valves and flushing units to see if all pulses were correctly assigned,
each valve should be tested in manual mode. To accomplish that, in the "Manual" tab please press the
"Manual" button, set the duration of the manual flushing and confirm with "OK".
To flush with the desired components, simply press the "OPEN" button. If you do not want to wait on
the process for the set time, just press the "CLOSE" button.
Important: Before leaving the side for manual flushing, switch the plant back into automatic.
3.1.12 Manual operation A- and B-valve in the group
To flush the added A- and B valves as a group, please proceed as follows:
In the "Manual" tab please press the "Manual" button, set the duration of the manual flushing
and confirm this with "OK".
To flush the group, check "Group" at the corresponding A-valve and in the related B-valve simpl
press the "Group OPEN" button. If you do not want to wait on the process for the set time, just
press the "CLOSE GROUP" button.
Important: Before leaving the side for manual flushing, switch the plant back into automatic.
- 22 -