IFM Electronic AC402S Programming Manual page 162

SmartPLC SafeLine AC4S with fieldbus interfaces
>
Output parameters
Parameter Data type
xActive BOOL
wCycleCount WORD
xError BOOL
wDiagnostic WORD
Diagnostic codes:

0x0000 No specific error is set

0xnF01 Unknown error

0xnF02 Unknown/invalid target

0xnF03 Unknown command ID

0xnF04 Unknown parameters

0xnF05 Timeout during processing
Legend:
1
Get_ASi_Data executes the FB ACnnnn_SysCmd sequentially with different command IDs in order to determine the individual
elements of the complex variable. In the returned error code, the nibble n indicates the command request where the error
occurred. n can have the following values:
1 = error with "Get LAS, LDA, LPF, LCE"
2 = error with "Get LPS"
3 = error with "Get CDI"
4 = error with "Get PCD"
5 = error with "Get Input Parameter"
6 = error with "Get Output Parameter"
7 = error with "Get LCEMS, LCEAS, LDAE"
162
Description
Signal confirms the FB execution
Counter for FB cycles that were fully
run through
Signal indicates whether errors
occurred while the FB was executed.
Diagnostic information
1
1
1
1
1
Possible values
FALSE Function block is inactive
TRUE FB is active (=is executed)
Number in hexadecimal representation
FALSE FB is disabled or is being
executed or FB was executed
without error.
TRUE An error occurred while the FB
was executed.
→ List below (Diagnostic codes)
42609