IFM Electronic AC402S Programming Manual page 144

SmartPLC SafeLine AC4S with fieldbus interfaces
>
Output parameters
Parameter Data type
abList_SA_Slave ARRAY[0..31]
OF BYTE
abList_B_Slave ARRAY[0..31]
OF BYTE
xReady BOOL
xBusy BOOL
xError BOOL
wDiagnostic WORD
Diagnostic codes:

0x0000 No specific error is set

0x0F01 Unknown error

0x0F02 Unknown/invalid target

0x0F03 Unknown command ID

0x0F04 Invalid parameters

0x0F05 Timeout during processing
144
Description
List of output parameters of S/A
slaves in the selected AS-i master.
Each byte contains the output
parameters of an AS-i slave.
– byte 0 (LSB) = res.
– byte 1 = slave with address 1(A) ...
– byte 31 = slave with address 31(A)
List of output parameters of B slaves
in the selected AS-i master. Each byte
contains the output parameters of an
AS-i slave.
– byte 0 (LSB) = res.
– byte 1 = slave with address 1B
...
– byte 31 = slave with address 31B
Signal indicates whether the execution
of the FB is completed.
Signal indicates whether the FB is
being executed.
Signal indicates whether errors
occurred while the FB was executed.
Diagnostic information
Possible values
Per byte:
Bits 0...3: P0-P3
Per byte:
Bits 0...3: P0-P3
FALSE FB is inactive or being
executed.
TRUE FB execution is completed.
FALSE FB is deactivated or FB
execution is completed.
TRUE FB execution has started but is
not yet completed.
FALSE FB is disabled or is being
executed or FB was executed
without error.
TRUE An error occurred while the FB
was executed.
→ List below (Diagnostic codes)
42533