Manage Pump Settings - Nordson AltaBlue Customer Product Manual

6-4
Configuring and Modifying Temperature, Pump and Melter Settings

Manage Pump Settings

Button
Pump Speed Manually fine­tune the pump RPM in either
Manual or Gear­to­Line mode.
Operation Mode Decide which pump operation mode,
Gear­to­Line or Manual you want to use.
S
Use Gear­to­Line to deliver adhesive
output at a rate proportional to the speed of
the production line.
NOTE: A line­speed input must be provided if
you want to use the gear­to­line capability.
S
Use manual to:
Auto Pump Make better use of your time by allowing you to
touch the Master Pump Control button while
the melter status indicates Heating (yellow)
and walk away to perform other tasks.
When the melter status indicates Ready
(green) the pumps automatically start.
NOTE: The Master Pump Control button
changes color to light blue if the Auto Pump
On option is enabled and...
Remote Control Enable or Disable a pump from a location
other than the melter console.
Part 1120130
The following table details each temperature settings.
Use this to....
S
Clean or purge the pump.
S
Deliver adhesive output at a continuous
rate.
S
You touch the Master Pump button
while melter is in the process of heating
the zones to their setpoint
temperatures.
S
You take the melter out of Standby
Mode, and you touch the Master
Pump button.
Default
(Recommended) Min: 0 (factory)
Min: 18 RPM Max: 94 RPM
Max: 80 RPM (Factory)
Manual Manual
Gear­to­Line
Disabled Disabled
Enabled
Disabled Disabled
Enabled
E 2011 Nordson Corporation
Range