Advertisement
Quick Links
r
Iso-Flo
HD and AN-8 Plus Gun Dolly System
Assembly
1. Introduction
2. Assembly
3. Initial Startup
1997 Nordson Corporation
All rights reserved
WARNING: Allow only qualified personnel to perform the
following tasks. Follow the safety instructions in this document
and all other related documentation.
This system consists of the following parts:
S
Manual Iso-Flo HD Voltage Block assembly
S
AN-8 Plus gun with hoses
S
electrostatic power supply
S
electrostatic cable
S
dolly
S
attaching hardware
See Figure 1
and refer to the parts list to assemble the system onto the
dolly.
WARNING: To prevent injury to personnel and damage to
equipment, read and understand each manual included with
this system.
1. Make sure that the electrostatic voltage is off.
2. Open the Iso-Flo door.
3. Supply water through the fluid inlet. Check for leaks.
4. Turn on the compressed air to the Iso-Flo system. Verify that the
setting is 5–7 bar (80–100 psi).
5. Turn on the fluid inlet pressure. Verify that the setting is 5–10.3 bar
(80–150 psi).
6. Trigger the gun until water comes out.
237 384A
Issued 4/97
Instruction Sheet
P/N 237 384A
Manual 10-30
Advertisement
Related Manuals for Nordson Iso-Flo HD
Summary of Contents for Nordson Iso-Flo HD
- Page 1 Follow the safety instructions in this document and all other related documentation. This system consists of the following parts: 1. Introduction Manual Iso-Flo HD Voltage Block assembly AN-8 Plus gun with hoses electrostatic power supply electrostatic cable dolly...
- Page 2 11. Make sure that the microamp draw on the electrostatic power supply is less than 100 ma. 12. Fill the system with coating material. Refer to Changing the Coating Material or Cleaning the System in the Manual Iso-Flo HD Voltage Block System Operator’s Card . See Figure 1.
- Page 3 Gun Dolly System Assembly 4. Parts (contd.) Connect Fluid Hose to Regulator Outlet To Cable Inlet on Iso-Flo Cabinet To Power Unit 1030001A Fig. 1 Assembly 1997 Nordson Corporation 237 384A Manual 10-30 All rights reserved Issued 4/97...
- Page 4 5. Nordson Technical Service at 1-800-275-6357. For assistance outside the United States, Service Help call your local Nordson representative. Iso-Flo, Nordson and the Nordson logo are registered trademarks of Nordson Corporation. Manual 10-30 237 384A 1997 Nordson Corporation All rights reserved...