Pump Drive Internal Filter; Other Considerations - Nordson AltaBlue Customer Product Manual

Pump Drive Internal Filter

Figure 3-5 Location of the pump drive internal filter inside a pump drive

Other Considerations

E 2011 Nordson Corporation
The AltaBlue melter is manufactured and shipped from the factory in
compliance with CE regulations. If the pump drive internal filter, located
inside each pump drive, is turned off, the melter will no longer be
CE‐compliant.
Consider the following additional factors when evaluating where to install the
melter.
S
The maximum distance between the melter and each applicator is
dictated by the power requirement of each hose. Refer to Appendix A,
Calculating Melter Power Requirements, for information about how to
determine the maximum allowable length.
S
The operator must be able to accurately monitor and safely reach the
touch screen display.
S
The operator must be able to safely observe the level of hot melt inside
the hopper/reservoir.
S
The melter must be installed away from areas with strong drafts or where
sudden temperature changes occur.
S
The melter must be installed where it will be in conformance with the
ventilation requirements specified in the Material Safety Data Sheet for
the hot melt being used.
S
The melter should not be exposed to excessive vibration.
Hardware Installation and Setup
3-7
Part 1120130