Replacing a Pump
E 2011 Nordson Corporation
Follow this procedure to replace a pump. You will need the following items:
S
tool kit, including a torque wrench
S
drain pan
S
cleaning supplies
S
replacement pump
S
replacement pump O‐rings
S
O‐ring lubricant
S
anti‐seize lubricant
NOTE: To rebuild a pump, contact your Nordson representative for
assistance.
1. Ensure the melter is at operating temperature.
2. Relieve system pressure. Refer to Section 1, Safety.
3. See Figure 7‐6. Close the tank isolation valve.
Figure 7-6
Location of the tank isolation valve
7-11
Service
Part 1120130