Printing a job on special material placed in a paper tray
Open the paper-compartment door, place the required paper and close the door.
1
Select the job in the mailbox.
2
Activate the 'Paper' section.
3
Make sure that the 'Paper input' card is open.
Check to insure that the required size and orientation are selected.
[35] Select the tray and the required paper size
[35] Select the tray and the required paper size
Press the start key .
4
Press the correction key
5
Press the correction key
6
the Océ VarioPrint 2045-65 NC.
Printing a job on special material placed in the special feeder
Place the required special material in the special feeder.
1
The face-down side is printed.
Select the job in the mailbox.
2
Activate the 'Paper' section.
3
Make sure that the 'Paper input' card is open.
4
Select 'Special feeder' in the 'Source' function box.
5
Select the size and orientation of the special material you inserted in the 'Size'
6
function box.
[36] The special feeder and the required paper are selected
[36] The special feeder and the required paper are selected
The print function
to leave your mailbox.
once more to enter the default operating mode of
61