Stop Or Correct A Print Job - Oce VarioPrint 2045-65 NC Job Manual

Stop or correct a print job

Introduction
A print job has the following phases (see 'Print jobs in this manual' on
page 32):
The job is stored in the mailbox on the DAC.
1
The job is printed when you print the job on the operator panel (mailbox job).
2
The job is printed when the job reaches the top of the print queue (automatic
job).
The table below displays the actions to take if you stop or correct a phase.
If
You notice an incorrect setting for
the mailbox job
You want to start a job while the jobs
from the print queue are being print-
ed
The printed sets are incorrect and the
job is not yet completed (phase 2)
You can interrupt the copy process before it has finished in order to start
Note:
a new job. The suspended job is continued after the new job is completed (see
'Interrupt a print job' on page 66).
You can delete jobs from the mailbox in order to prevent the mailbox from
Note:
becoming full (see 'Control the mailbox jobs' on page 56).
Correcting: when you make the print job settings
If you press the correction key
Once
64 Océ VarioPrint 2045-65 NC Job Manual
Then
Correct the mailbox job setting.
Stop the printing of the print queue.
Stop the printing process.
Then
The Océ VarioPrint 2045-65 NC re-
stores the settings as defined in the
Océ VarioPrint 2045-65 NC printer
driver.