Wdmx (Wifly) Set Up; Offset Menu - ADJ VIZI CMY300 User Instructions

WDMX (WIFLY) SET UP

With this feature you are able to control the unit with DMX without the need of XLR cables. Your DMX
controller must be connected to a ADJ WiFly TransCeiver or have WiFly wireless DMX remote to use this
function. You are able to communicate up to 2500 feet/760 meters (open line of sight).
1. Follow the instructions on pages 27-28 to activate WiFly and set the Wireless address. The address must
match the address set on the WiFly Transceiver.
2. After you have set the WiFly address, follow the DMX instructions on page 27 to select your desired DMX
Channel mode and set your DMX address.
3. Apply power to the ADJ WiFly Transceiver. The fixture must be set up first before you apply power to WiFly
Transceiver.
Note: If the sync does not work, switch the WiFly power off then on again.

OFFSET MENU

ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION!
This function allows small adjustments to be made to the multiple fixture settings to compensate for movement
misalignment and/or when a sensor has been knocked slightly out of position. Improper use of this function
can result in undesired operation of this fixture compared to others being used at the same time. Because this
can be an extremely detailed procedure, careful consideration must be used before making any changes.
Please contact our customer support team for step-by-step instructions and guidance.
To enter the Offset Menu, press the ENTER button for at least 3 seconds.
To enter the Offset Menu, press the ENTER button for at least 3 seconds. In this submenu you are able to
adjust the home position of the pan, tilt, shutter, color wheel, both gobo wheel's, RGobo (Rotating) wheel,
prism, R (Rotating) Prism, and focus position.
A.D.J. Supply Europe B.V. – www.adj.eu – Vizi CMY300 Instruction Manual Page 31