Wifly Set Up I Wifly Master-Slave Set Up - ADJ ELEMENT HEXIP User Instructions

Element HEXIP
This unit can only be controlled using WiFly. Your DMX controller must be connected to a ADJ WiFly
Transceiver to use this function. You are able to communicate up to 2500 feet/760 meters (open line
of sight).
1. Follow the instructions on page 20 to set the WiFly address and to activate WiFly. The address
must match the address set on the WiFly WiFly Transceiver.
2. After you have set the WiFly address, follow the DMX instructions on page 19 to select your
desired DMX Channel mode and set your DMX address.
3. Apply power to the ADJ WiFly Transceiver. The fixture must be set up first before you apply
power to WiFly Transceiver.
4. If everything is set up properly and the fixture is receiving a Wireless signal, you should now be
able to control it with a DMX controller.
Element HEXIP
Master-Slave Set Up:
This function will allows you to link units together to run in a Master-Slave setup. In a Master-Slave
set up one unit will act as the controlling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave however, only one unit can be programmed to
act as the "Master."
1. Follow the instructions on page 20 to set the WiFly address and to activate WiFly. The addresses
on each fixture must be the same.
2. After you have set the WiFly address, select your "Master" unit and set your desired operating
mode.
3. For the "Slave" unit(s), put the unit in Slave mode. See page 20 "Slave Setting" to set the unit as
a Slave.
4. If everything is set up correctly, the "Slave" units will start following the "Master" unit.
ADJ Products, LLC - www.adj.com - Element HEXIP User Manual Page 21
WiFly Set Up
WiFly Master-Slave Set Up