Wifly Set Up I Wifly Master-Slave Set Up - ADJ ELEMENT ST HEX User Instructions

Element ST Hex
BATTERY - The submenus listed under BATTERY are as follows: Charging Time, Current Life,
Operation Mode, and Load Mode.
- CHARGING TIME - This submenu is used when charging the unit. It allows you to check the
status of the charging time.
- CURRENT LIFE - This submenu allows you to check the battery life.
- OPERATION MODE - In this submenu you are able to select and set your desired energy saving
mode.
- LOAD MODE - In this submenu you are able to activate/deactivate the LED PCB output.
NOTE: This function needs to be activated when using battery power or AC power. For faster
charging switch this setting to "OFF".
Element ST Hex
This unit can only be controlled using WiFly. Your DMX controller must be connected to a ADJ
WiFly Transceiver to use this function. You are able to communicate up to 2500 feet/760 meters
(open line of sight).
1. Follow the system menu diagram on page 16 to set the WiFly address and to activate WiFly. The
address must match the address set on the WiFly Transceiver.
2. After you have set the WiFly address, follow the system menu diagram on page 16 to select your
desired DMX Channel mode and set your DMX address.
3. Apply power to the WiFly Transceiver. The fixture must be set up first before you apply power to
WiFly Transceiver.
4. If everything is set up properly and the fixture is receiving a Wireless signal, you should now be
able to control it with a DMX controller.
Element ST Hex
WiFly Master-Slave Set Up:
This function will allow you to link units together via WiFly to run in a Master-Slave setup.
1. Follow the system menu diagrom on page 16 to set the WiFly address and to activate WiFly. The
addresses on each fixture must be the same.
2. After you have set the WiFly address, select your "MASTER" unit. Activate the "MASTER" setting
by following the system menu diagram on page 16.
3. Set the "MASTER" unit to your desired mode of operation. On the "SLAVE" unit(s) follow the system
menu diagram on page 16 to activate the "SLAVE" setting.
4. If everything is set up correctly, the "SLAVE" unit(s) will start following the "MASTER" unit.
ADJ Products, LLC - www.adj.com - Element ST Hex User Manual Page 18
System Menu
WiFly Set Up
WiFly Master-Slave Set Up