Wifly Setup - ADJ ELEMENT H6 PAK User Manual

W I F L Y S E T U P
These devices do not feature physical DMX connector ports. Therefore, in order to utilize DMX
control, the user must first set up the devices to run wireless DMX control. Follow the direc-
tions below to configure wireless DMX control:
1. First, select the DMX Channel Mode for that you would like the device to operate in. Press
MODE until the the "DMX Settings" menu is displayed on the screen. Use the UP or DOWN but-
tons to scroll to "DMX Channel Mode," then press the SETUP button.
2. Use UP or DOWN to scroll through the DMX Channel Mode options, then press SETUP to con-
firm your selection.
3. Next, enable the device's Wifly capability. Press MODE until the "Personality" menu is displayed
on the screen, then use UP or DOWN to scroll to "Wifly Settings" and press SETUP.
4. Use UP or DOWN to scroll to "Enable Wifly," then press SETUP to select this option.
5. Use UP or DOWN once again to toggle this setting to "Yes," then confirm by pressing SETUP.
6. Next, select the Wifly channel. Press MODE until the "Personality" menu is displayed on the
screen again, then use UP or DOWN to scroll to "Wifly Settings" and press SETUP.
7. Use UP or DOWN to scroll to "Set Wifly Channel," then press SETUP again.
8. Now use UP or DOWN to scroll to your desired Wifly channel. Selectable values range from 00
to 14.
9. Finally, set the DMX address. Press the MODE button until the "DMX Settings" menu is displayed
on the screen, then use UP or DOWN to scroll to "DMX Address," then press SETUP.
10. Use the UP or DOWN buttons to scroll to your desired DMX address, then press SETUP to con-
firm your selection. Available values range from 001 to 512. Refer to the DMX Addressing section
of this manual for detailed guidance. Repeat these steps for each individual unit that you wish to
use.
12