ADJ VIZI CMY300 User Instructions page 8

MOUNTING (continued)
NOTICE: The suitable environmental temperature for this lighting fixture is between -25˚ C to 45˚ C. Do not
place this lighting fixture in an environment where the temperatures are under or above the temperatures
stated above. This will allow the fixture to run at its best and help prolong the fixture life.
1. Bolt each clamp to the Omega holder with screw and lock nut through the hole in the holder.
2. Fasten the Omega holders on the bottom of the base by inserting quick-lock fasteners into the holes of the
base and tighten fully clockwise.
3. Hang the fixture to the support using the clamps and tighten the screws. Fasten a safety cable through the
bottom of the base and over the support.
Screw one clamp each via a M12 screw and nut into the Omega holders. Insert the quick-lock fasteners of the
Omega holder's into the respective holes on the bottom of the Vizi CMY300. Tighten the quick-lock fasteners
fully clockwise. Install the second Omega holder. Pull the safety-cable through the openings located on the
base plate and over the trussing system or a safe fixation spot. Insert the end in the carabine and tighten the
safety screw.
A.D.J. Supply Europe B.V. – www.adj.eu – Vizi CMY300 Instruction Manual Page 8
1. Clamp
2. Omega-holders
3. Quick-lock fastener