Gobo Specifications - ADJ VIZI CMY300 User Instructions

GOBO SPECIFICATIONS

Due to the high temperature optical system, special BOROFLOAT glass material and design requirements are
required.
Due to varying gobo manufacturing processes and tolerances, it is highly recommended to provide a gobo and
gobo holder/wheel sample from the fixture to the custom gobo vendor for accurate sizing. Gobo specifications
below including diameter, thickness, and materials have been tested and are compatible in this fixture.
Using custom gobos that do not match the gobo specifications below, is not recommended and any damage to
the fixture as a result of using a custom gobo is NOT covered under warranty.
Extended testing of custom gobo designs is highly recommended prior to using.
PLEASE CONTACT ADJ CUSTOMER SUPPORT FOR FURTHER INFORMATION
MAX THICKNESS
GOBOS 1,2,3,5,6,7 ARE SECURED IN THE GOBO HOLDER WITH A RETAINER SPRING AND HIGH
TEMPERATURE SILICONE SEALANT.GOBO 4 IS SECURED WITH A HIGH TEMPERATURE SILICONE
SEALANT ONLY, NO RETAINER SPRING.
NO METAL BEZELS ARE USED TO SECURE ANY OF THE FACTORY GOBOS.
IMPORTANT NOTICE REGARDING CUSTOM GOBOS
* * *
O.D.
(Max. Outer Diameter)
I.D.
(Max. Image Diameter)
Gobo Holder Diameter
Thickness
Material
A.D.J. Supply Europe B.V. – www.adj.eu – Vizi CMY300 Instruction Manual Page 35
MAX O.D.
MAX I.D.
Φ26.8mm -0.15mm
Φ20mm
Φ27.00mm -0.05mm
1.1mm ±0.1mm
BORFLOAT GLAAS
* * *
.
*GOBO HOLDER