Table of Contents
Advertisement
DMX SET UP
DMX-512: DMX is short for Digital Multiplex. This is a universal protocol used as a form of communication
between intelligent fixtures and controllers. A DMX controller sends DMX data instructions from
the controller to the fixture. DMX data is sent as serial data that travels from fixture to fixture via the
DATA "IN" and DATA "OUT" XLR terminals located on all DMX fixtures (most controllers only have a
DATA "OUT" terminal).
DMX Linking: DMX is a language allowing all makes and models of different manufactures to be
linked together and operate from a single controller, as long as all fixtures and the controller are DMX
compliant. To ensure proper DMX data transmission, when using several DMX fixtures try to use
the shortest cable path possible. The order in which fixtures are connected in a DMX line does not
influence the DMX addressing. For example; a fixture assigned a DMX address of 1 may be placed
anywhere in a DMX line, at the beginning, at the end, or anywhere in the middle. When a fixture is
assigned a DMX address of 1, the DMX controller knows to send DATA assigned to address 1 to that
unit, no matter where it is located in the DMX chain.
Data Cable (DMX Cable) Requirements (For DMX Operation): The 7P Hex IP can be controlled via
DMX-512 protocol. The 7P Hex IP has 4 DMX channel modes. The DMX address is set on the rear panel
of the 7P Hex IP. Your unit requires a standard 5-pin XLR connector for data input
SOUND
and data output. We recommend Accu-Cable DMX cables. If you are making your own cables,
be sure to use standard 110-120 Ohm shielded cable (This cable may be purchased
at almost all pro lighting stores). Your cables should be made with a male and
female XLR connector on either end of the cable. Also remember that DMX cable
must be daisy chained and cannot be split.
REMOTE
INPUT
OUTPUT
CONTROL
INPUT
POWER
DMX512
DMX+,DMX-,COMMON
SOUND
9
REMOTE
INPUT
OUTPUT
CONTROL
INPUT
POWER
Termination reduces signal erro
avoids signal transmission pr
1
and interference. It is always ad
3
to connect a DMX terminal, (Res
2
120 Ohm 1/4 W) between PIN 2
and PIN 3 (DMX +) of the last
SOUND
Advertisement
Table of Contents
