Operating Instructions - ADJ VIZI CMY300 User Instructions

OPERATING INSTRUCTIONS

System Menu: When making adjustments press ENTER to confirm your setup then press and hold the
MENU button for at least 3 seconds. To exit without making any adjustments press the MENU button.
The display will lock after 30 seconds, press the MENU button for 3 seconds to unlock.
DMX FUNCTIONS -
DMX Address - With this function, you can adjust the DMX address via the Control Board.
1. Access the main menu, and press the UP or DOWN buttons so that "DMX Functions" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "DMX Address" is displayed, and press ENTER. The current DMX
address will now be displayed.
3. Use the UP or DOWN buttons to adjust the DMX address.
4. Press ENTER to confirm or press MENU button to return to the main menu.
DMX Channel Mode - With this function, you can select the DMX channel mode.
1. Access the main menu, and press the UP or DOWN buttons so that "DMX Functions" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "DMX Channel Mode" is displayed, and press ENTER. The current
DMX channel mode will now be displayed.
3. Press the MENU button to return to the main menu.
DMX State - This mode can be used as a precaution mode, that in case the DMX signal is lost, interrupted, or
power is lost, the operating mode chosen in this setup is the running mode the fixture will go into when the
DMX signal is lost. You can also set this as the running mode you would like the unit to return to when power
is applied.
1. Access the main menu, and press the UP or DOWN buttons so that "DMX Functions" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "DMX State" is displayed, and press ENTER. Use the UP and DOWN
buttons to switch between the two modes; Blackout or Hold. Press the ENTER button to make your selection.
• LAST STATE - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is applied and
this mode is set, the unit will automatically go into the last DMX set up.
• BLACKOUT - If the DMX signal is lost or interrupted, the unit will automatically go into stand by mode.
3. Press the MENU button to return to the main menu.
DMX Value - This function will allow you to see the DMX value of each DMX channel that is currently being
used at the time.
1. Access the main menu, and press the UP or DOWN buttons so that "DMX Functions" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "DMX Value" is displayed, and press ENTER.
3. A DMX Channel will be displayed. Example: Prism, Color Wheel, Gobo Wheel, etc... Press ENTER when
you find the DMX channel that you would like to check. When you press ENTER the DMX value of that
channel will displayed.
4. Press the MENU button to exit and return to the main menu.
WDMX On/Off - In this submenu you can activate the wireless DMX function.
1. Access the main menu, and press the UP or DOWN buttons so that "DMX Functions" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "WDMX On/Off" is displayed, and press ENTER.
3. Either "On" or "Off" will displayed. To activate Wireless DMX press the UP or DOWN so that "On" is
highlighted and press ENTER.
4. Press the MENU button to exit and return to the main menu.
A.D.J. Supply Europe B.V. – www.adj.eu – Vizi CMY300 Instruction Manual Page 27