Bushes And Press Fits; Cables And Wires; Locking Devices; Fitting Bolts In Blind Holes - Valtra 6000 Workshop Manual

12. Repairs
4
The main parts of lip ---type seal:
1. Case
2. Sealing element
3. Ring spring
The figure above shows the construction of a simple lip ---type
seal. The cross section shows the heel (4) and the toe (5),
used to identify the sides of a single element seal. With a few
exceptions, the toe of a single ---lip is located on the lubricant
side. Some seals have a second auxiliary lip which has no
spring.

Cables and wires

When removing or disconnecting a group of cables or wires,
label each one to ensure correct refitment.

Locking devices

Correct and incorrect use of retainers
5
3
2
1
13
Model
6000-- 8750
8. 11. 1990
Correct and incorrect method of fitting and bending locking
tabs.
Slackening of nuts and bolts is prevented by mechanical
means such as lockwashers, tab washers and cotter pins, or
by Loctite ---type locking agents.
Flat retainers must be installed properly to be effective. Bend
one end of the retainer against the edge of the part. Bend the
other end against one of the nut or bolt head.Always fit new
retainers in compartments which house moving parts. When
fitting lockwashers on aluminium housings,
washer between the lockwasher and the housing.
Note!
1) Never fit a lockwasher (Grower, fan, spring, etc.) under a nut
or bolt to which a specified torque has to be applied.
2) Always thoroughly degrease components before applying
Loctite type locking agents.

Bushes and press fits

Do not fit bushes with a hammer alone. Use a suitable fitting
tool and a hammer or, better still, a press if possible..
When using a press, ensure that pressure is applied directly
in line with the bore. If the ring has an oil hole, take care to align
it with the oil hole in the mating part. When press fitting a part
into another part, lubricate the mating surfaces. Tapered parts
should be assembled dry. Before assembly, check that the
tapers are dry and free from burrs.

Fitting bolts in blind holes

Use bolts of the correct length. A bolt which is too long may
"bottom" before the head comes into contact with the part it
is to hold: this will cause damage to the threads. If a bolt is too
short, there may not be enough threads engaged to hold the
part securely.
Code Page
120 3
place a flat