Bypass All Faults And Tamper Conditions (Except Zone Tamper); Enable Disable Installer Code User's Access; Change Individual Code; Setting Date And Time - Bosch AMAX panel 2000 Installation Manual

AMAX panel 2000 / AMAX panel 2000 EN
1.
2.
3.
4.
5.
6.12

Bypass all Faults and Tamper conditions (Except zone Tamper)

This function allows code holders to bypass faults and Tamper conditions.
1.
NOTICE!
This function works only if loction 183 is 0=disabled. If location 183 is 1=enabled, Faults and
Tamper conditions are automatically overwitten.
6.13

Enable Disable installer code user's access

This function allows user code holder to enable or disable the installer code user to access
the programming mode
1.
2.
6.14

Change individual code

This function allows user to change there individual codes.
1.
2.
NOTICE!
This function is terminated automatically if you do not press a button within 240 sec or if
youpress [#] . One long beep indicates that the code already exists or that an incorrect
number has been entered.
6.15

Setting date and time

This function allows installer code holder to set or view the date and time
1.
2.
3.
Example
Bosch Sicherheitssysteme GmbH
Enter your Code + [96] and press [#] .
Two beeps sound and the STAY and AWAY indicators flash.
Zone type for Zone 1 is shown. Refer to Section Zone Types, page 84
Press [#] to jump to Zone 2
Two beeps sound and the STAY and AWAY indicators flash.
Repeat this procedure to jump to the other Zones.
To exit this function press [*]
Enter your code + [97] and press [#].
Two beeps sound.
Enter your user code +[98] and press [#] to enable the function
Two beeps sound
Enter your user code + [98] and press [*] to disable the function
Two beeps sound
Enter your Code + [99] and press [#] .
Two beeps sound and the STAY and AWAY indicators flash.
Enter the new code and press [#].
Two beeps sound and the STAY and AWAY indicators are extinguished.
Enter your installer code +955 and press [#]. Two beeps sound, the STAY and AWAY
indicators flash and date + time is shown in the format YYMMDD HHMM.
Enter the year, month, day, hour and minute in YY, MM, DD, HH, MM format and press [#].
Use 24:00 hour format when programming the hour of the day. Beep sound and the
STAYand AWAY indicators are deactivated. If a long beep sounds, it indicates an
erroneous entry of date and time.
If operation is not carried out within 240 seconds after entering the date and time
setting interface, the system will automatically exit from the setting.
Installation Manual
System Functions | en 43
F.01U.241.127 | V4 | 2011.12