Bosch AMAX panel 2000 Installation Manual page 15

AMAX panel 2000 / AMAX panel 2000 EN
Enter the four-digit installer code (the factory default is 1234) + (958) and press [#] .
Two beeps sound and the STAY and the AWAY indicators flash simultaneously to indicate that
you have entered into installer's programming mode.
Once you enter into installer's programming mode, you are automatially positioned at location
000, the first digit of the IP Address/ primary telephone number for receiver 1. The keypad
indicators display the current data stored in this location.
Data
Value
Table 3.2 Keypad Indicators
To move to a different programming location:
Enter the location number and press [#] .
For example, press [1 7][#] to automatically position you at the beginning of the subscriber ID
number 17 for receiver 1. The data stored in the new location appears.
To move to the next location:
Press [#] .
For example, if you are currently positioned at location 017, press [#] to move to location
018.
To move to the previous location:
Press [*] .
For example, if you are positioned at location 018, press [*] to move back to Location 017.
To change data in the current location:
Enter the new value (0 - 15) and press [*] .
The data is stored and you remain positioned at the same location. The keypad indicators
display the new value (for example, if you enter [1 4] and press [*] , the zone 4 and MAINS
indicators are lit).
To exit from installer's programming mode + save data:
Enter command [9 6 0] and press [#].
Two beeps sound and the STAY and AWAY indicators are deactivated. The system returns to
the disarmed state and is now ready for use.
Bosch Sicherheitssysteme GmbH
Zone Indicators
1 2
0
1 X
2 X
3
4
5
6
7
8
9 X
10
11 X
12 X
13
14
15
Installation Manual
3 4 5
X
X
X
X
X
X
Installation | en
6 7 8
X
X
X
X
F.01U.241.127 | V4 | 2011.12
15
Mains
X
X
X
X
X
X