Warning Device 1 Short; Warning Device 2 Disconnected; Warning Device 2 Short; Telephone Line Fault - Bosch AMAX panel 2000 Installation Manual

34 en | Fault and Tamper Description
4.
5.3.2

Warning Device 1 Short

Condition:
Warning Device output is shorted.
Restore:
Warning Device output short is removed and fault is reset.
Supervise:
1.
2.
3.
4.
5.3.3

Warning Device 2 Disconnected

Condition:
Warning Device is disconnected.
Restore:
Supervise:
1.
2.
3.
4.
5.3.4

Warning Device 2 Short

Condition:
Warning Device output is shorted.
Restore:
Warning Device output short is removed and fault is reset.
Supervise:
1.
2.
3.
4.
5.4

Telephone Line Fault

Condition:
Telephone line is broken or disconnected.
Restore:
Telephone line is restored or connected and fault is reset.
Supervise:
1.
2.
F.01U.241.127 | V4 | 2011.12
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Monitor the voltage by MPU.
Report the siren fault to the configured destination programmed on location 140.
Slow flash FAULT indicator (refer to the detailed description in chapter keypad
indicators)
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Monitor the voltage by MPU.
Report the siren fault to the configured destination programmed on location 140.
Slow flash FAULT indicator (refer to the detailed description in chapter keypad
indicators)
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault
Monitor the voltage by MPU.
Report the siren fault to the configured destination programmed on location 140.
Slow flash FAULT indicator (refer to the detailed description in chapter keypad
indicators)
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault
Monitor the telephone line by MPU all the time when the telephone is idle.
Report the telephone line fault to the configured destination programmed on location
140.
Installation Manual
AMAX panel 2000 / AMAX panel 2000 EN
Bosch Sicherheitssysteme GmbH