Operational Data Indicator - Eaton PowerXL DC1 Manual

5.6 Operational data indicator

PNU ID
P-00 - Display values
P00-01 20
P00-02 21
P00-03 22
P00-04 11
P00-05
P00-06
P00-07
P00-08 23
P00-09 24
P00-10
P00-11
P00-12
When the specified supply voltage is applied (L1/L, L2/N, L3), the 7-segment
LED display will light up (Power ON); the display will show Stop.
You can use arrow keys ▲ and ▼ to select the operational data indicator you
want (parameter number P00-...) in the "Monitor" (P-00...) menu. You can tell
the display to stop alternating between the parameter number and the
display value and only show the display value instead by pressing the OK
button. In order to access other operational data indicators, you will have to
press the OK button again. You can then make your selection using the ▲
and ▼ arrow keys and confirm it with the OK button.
￫
The values of the operating data display cannot be changed by
hand (i. e. by value entry).
Access Value
right
ro/rw
ro %
ro %
ro Hz/rpm
ro Status
DI1 - DI4
ro 0
ro 0
ro V
ro V
ro °C
ro HH:MM:SS
ro HH:MM:SS
ro HH:MM:SS
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com
Description
Analog input 1
100 % = Maximum input voltage
Analog Input 2
100 % = Maximum input voltage
Frequency reference value / Motor shaft speed
Shown in Hz if P-10 = 0; otherwise shown in revolutions per minute
Digital inputs 1 - 4
State of the variable frequency drive's digital input
Reserved
Reserved
Motor voltage: the value of the rms voltage being applied at the motor
Internal DC bus voltage
Unit Temperature
Heatsink temperature in °C
The variable frequency drive's operating time
Not affected when the parameters are reset to their default settings.
The variable frequency drive's operating time since the last trip
Operating time clock stopped by variable frequency drive lockup (or trip). Reset with next
enable only if a trip occurred. Also reset with next enable after the variable frequency
drive's mains power is switched off.
The variable frequency drive's operating time since the last trip
Operating time clock stopped by variable frequency drive lockup (or trip). Reset with next
enable only if a trip occurred (undervoltage does not count as a trip) – Not reset when mains
power is switched off/on unless a trip occurred before the mains power was switched off.
5 Parameters
5.6 Operational data indicator
103