Eaton PowerXL DC1 Manual page 54

10 Error Messages
10.3 Error list
Failure View
code [hex]
09
V-t
0A
P-dEF
0B
E-triP
0C
SC-trF
0E
P-LoSS
0F
SPIn-F
10
th-Frt
11
dAtA-F
12
4-2OF
166
Designation Possible cause
Excessively low Excessively low heat sink temperature
temperature (frost)
Parameter Default The parameter's default setting has
been loaded.
External fault • External shutdown (on digital input
3)
• PTC overtemperature (motor)
Communication fault Communication loss error
Mains connection Input phase loss
phase fault Shutdown
Motor pick-up control Motor pick-up control function (for
fault catching spinning motors) failed
Thermistor fault Defective thermistor on heat sink
Data error Internal memory error
Live zero error Analog input current outside range
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com
Notes
• The variable frequency drive will be switched
off if the ambient air temperature is lower than
-10 °C.
• Raise the temperature over -10 °C in order to
start the variable frequency drive.
Press the STOP pushbutton.
The DC1 variable frequency drive is ready for an
application-specific configuration.
• External safety shutdown at digital input 3. The
N/C contact has opened due to some reason.
• If a motor thermistor is connected, check
whether the motor is too hot.
• Check the communications connection between
the variable frequency drive and the external
devices.
• Make sure that each individual variable
frequency drive on the network has a unique
address.
• A variable frequency drive intended for use with
a three-phase power supply has lost one of its
input phases.
• The motor pick-up control function did not deter-
mine the motor speed.
• Please contact your closest Eaton representa-
tive.
• Parameter not stored; restore default settings.
• If the problem occurs again, please contact your
closest Eaton representative.
• Make sure that the input current falls within the
range defined in parameter P-16.