Eaton PowerXL DC1 Manual page 24

Variable frequency drive

Hide thumbs Also See for PowerXL DC1:

Table of Contents

h Motor connection with output voltage U

The connection in the motor feeder is implemented with a screened cable that is earthed on both sides

across a large area (PES).

Rated operational current (I

DC1-1D...: 2.3 - 5.8 A

DC1-12...: 2.3 - 15 A

DC1-32...: 2.3 - 18 A

DC1-34...: 2.2 - 24 A

100% at an ambient temperature of +50 °C with an overload capability of 150% for 60 s

and a starting current of 175% for 2 s.

i Three-phase asynchronous motor

Continuously variable speed control for motors with the rated motor shaft outputs (P

DC1-1D...: 0.37 - 1.1 kW (230 V, 50 Hz) or 0.5 - 1.5 HP (230 V, 60 Hz)

DC1-12...: 0.37 - 4 kW (230 V, 50 Hz) or 0.5 - 5 HP (230 V, 60 Hz)

DC1-32...: 0.37 - 4 kW (230 V, 50 Hz) or 0.5 - 5 HP (230 V, 60 Hz)

DC1-34...: 0.75 - 11 kW (400 V, 50 Hz) or 1 - 15 HP (460 V, 60 Hz)

j Control section with operating unit and control buttons, seven-segment display, control voltage,

plug-in control signal terminals

k RJ45 interface for the computer and fieldbus connection (OP bus, Modbus RTU, CANopen)

DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com

(0 to 100% U

) and output frequency f

, output current):

1 DC1 device series

1.7 Features

(0 to 500 Hz)

Table of Contents