Designations For The Elements In Variable Frequency Drives With An Ip66 Degree Of Protection - Eaton PowerXL DC1 Manual

1.6 Designations for the elements in variable frequency drives with an IP66 degree of protection

1.6 Designations for the elements in variable frequency drives with an IP66 degree of protection
The following drawing serves as an example showing the designations used
for the elements in DC1 variable frequency drives with a size of FS1 and an
IP66 degree of protection.
⑨
⑧
⑦
Figure 7: Designations (IP66)
a Local controls with connection (in DC1-...-A6SN only)
Setpoint potentiometer
Selector switch for switching operating directions
Mains transfer switch (lockable)
b Operating unit with 5 control buttons and LED display
c Control signal terminal strip (plug-in)
d Connection terminals in power section (motor feeder) and cableway for EMC cable gland
e Nameplate
f Fixing holes (screw fastening)
g Heat sink
h Connection terminals in power section (mains side) and cableway for cable gland
i Communication interface (RJ45)
The info card and three additional knockouts for cable glands are found under
the lower terminal cover.
DC1 variable frequency drive 12/13 MN04020003Z-EN www.eaton.com
1 DC1 device series
①
②
③
④
⑤
⑥
19